Now there's an even easier way to keep your pool in perfect shape. The Synergy System
makes your pool care easy and keeps your water sparkling clear all
season long. Just follow the steps below to make sure your pool
is ready for summer.
Starting Up Your Synergy® Pool
- Balance the swimming pool water to proper levels. pH,
Alkalinity and Hardness levels should be checked at a minimum.
Clean all pool surfaces - vacuum and brush where needed. You can
find a list of ideal chemical ranges here: Balancing Your Pool Water
- To start your swimming pool on Synergy®, add a once a year dose of Synergy Initiator
at a rate of one 12.5 pounds per 10,000 gallons. Initiator
prepares the pool to use the Synergy system and helps keep the water
looking its best. Add Initiator through the pool skimmer with the
pump running. Do not backwash for 48 hours.
- Establish an initial chlorine residual of at least 2 ppm. To do this, add 1 Lb. of OMNI Breakout 60
per 10,000 gallons. Test chlorine residual after 12-24
hours. If less than 2 ppm, repeat application and testing until a
2 ppm or more residual is obtained.
- Turn your chlorinator or floater down to its lowest setting and fill with Synergy Tabs
Maintaining your Synergy Pool
Once A Week:
- Add Synergy Clear
to the pool water at a rate of 1/2 pound per 10,000 gallons. You
may swim 15 minutes after adding Synergy Clear to your pool.
- Refill your chlorine floater or automatic chlorinator with Synergy Tabs
- Use a Chlorine Test Strip to check your pool water. Keep a free chlorine residual of 1.0 - 1.5 ppm and a pH of 7.2 - 7.6
- Check and adjust water balance if necessary.
- Brush and vacuum debris as needed.
Visit our online store at: http://www.focuspools.com/
